Spiral Ball Nose End Mill CNC Router Bits For Wood Tungsten Carbide Milling Route Tool Fresa CNC Tools
End design:ball nose
Shank diameter:3.175mm
Cutting edge diameter:2mm/0.08"
Cutting edge length:17mm/0.67"
Total length:approximately 39mm/1.53"
Features:
-Non stick knife, tasteless, quiet, blade design, sharp
-Clean, tidy, no burr
-Spiral chip design, chip smooth, reduce heat
-Applies to the relief process of sub GREE, PVC, density board, hard wood
Operation
1 for the design of portable and desktop woodworking engraving
machine, can not be used in drill machine.
2 smooth surfaces, such as wood, to avoid the processing of copper,
iron and other metal and sand, stone and other non wood materials.
3 use appropriate size clip.
4 tool clamping, found that the knife has a beating phenomenon, should
immediately stop, repeat clip a few times to get the tool shank and fixture
to get full contact, and then work.
5 cutter handle and the clamping sleeve contact should be good, a tool
shank must be fully inserted into the jacket, tighten firmly.
Your message must be between 20-3,000 characters!
